Crystal
How do you Swarvoski Crystal SunCluster?
I would like to know how to make the crystal clusters that look like they can stick, or perhaps wired. There are usually 10-14 Crystals in a cluster.
This is an approximation of what you want to do, maybe it is you and you can start to improvise as you go along. Here's what you need around the Crystal and Silver Zig Zag Beaded Bracelet: 24 - Top drilled 8mm Swarovski Crystals 26 - 6mm Swarovski Rondelles - Silver with clear stones, 2 - 6mm Swarovski bicone crystals, drilled end to end 12 - Inch Soft Flex Beading Wire 2 - 10mm French piece of wire 2 - Twisted Tornado Crimp, Silver Cut 1 - Sterling Silver 10mm toggle closure set with a piece of wire, attach one end of the brace at the end of the wire with the Twisted Tornado crimp, the French Wire and the toggle clasp. Once the switch is closing rather than a paper clip the tail to about 5 mm. Make sure you have a good, stable crimp, so that the Not break through the crimp beads if the bracelet is finished. Add one of the two 6mm Swarovski bicone beads. Make sure that the ends of two wires and The wire tail within this crystal. Add a Swarovski Rondell, a top-drilled Swarovski crystal, Swarovski have Rondell and other top-drilled Swarovski crystal beading around the Wire. Have continued pattern of step four until all of the top-drilled Swarovski crystals and all the roundel on your wire. Each end of the bracelet should be next to the 6mm Rondelle Swarovski crystal. Finish the bracelet by using the Twisted Tornado crimp, the French wire and seal. Pass the stringing wire back through the crimp and the 6 mm crystal. This can be a bit complicated, but you must make sure that you are a lot of tension on the wire before you crimp. Press the Crystals, and keep the wire instead of solid, before the crimp. That leaves you enough to create tension on the wire to keep the crystals in their zig-zag position.
